E80 raymarine manual

Classic displays C80, E80, C, E require adaptor kit R or R and require a small amount of cutting and drilling as indicated on the adaptor mounting templates. To determine what adaptor kit you require please see our matrix. Download instructions. Download template. These features are available. Download the mounting templates. Marine Electronics Reviews Facebook Twitter. Facebook Twitter. Raymarine E80 Review by NavGuy. E80 has same features as E Only difference is screen size.

Waypoint symbols and groups. Additional storage available on CompactFlash cards. Software also available to convert waypoints to Excel file.

Screen functions — Full, half and quarter screens available dependant on function. Relative, Autorange or True Motion. Screen offset. Radar or 3D synchronization. Routes — A route plan may contain up to 50 waypoints. Up to routes can be stored in the units internal memory. SmartRoute to create a route from track history. Track optimization reduces number of points used or user selectable time or distance interval.

Set up a safe zone. Bearing and distance to waypoint. Bearing and distance to cursor and ETA. Ensure the power supply is switched off before making any electrical connections. Ensure that the scanner has been installed in accordance with the recommendations given in the relevant scanner handbook.

WARNING: Fishfinder sounder module Removing the transducer cable from the rear of the fishfinder sounder module whilst it is switched on can cause sparks. Only remove the transducer cable after power has been switched off. Ensure that the sounder module is mounted where it is well ventilated and in an area free from flammable vapors. Always observe the appropriate precautions when handling, shipping and storing this product.

Failure to do so could result in permanent damage to the equipment. A warning on the display indicates when the card is being accessed. Care should be taken not to damage this plate. Introduction This section gives step-by-step details for dismantling and reassembling both E80 and E displays. Before starting work on a E-Series display attention should be given to the safety notices at the start of this section.

The numbers in brackets correspond with the item numbers shown in the Exploded Views on pages 9 and 10 of this manual. To remove an E80 or E This section describes how to remove an E80 or E display from its mounting. Flush mounted 1. Disconnect the power source to the display. Unclip the bezel 2. Dispose of the flush mount seal You are now ready to dismantle the E80 see page 6 or E see page 7. Trunnion mounted 1. Unscrew the trunnion knobs 43 and remove the unit from the trunnion brackets Without scratching the front plate 4 , remove the 17 countersunk screws 3.

Retain the screws for later use. Carefully remove the front plate 4. Remove and discard the window seal 5. Remove the lower keymat 7. There is no need to remove the rotary control knob 8 or the side keymat 9 unless they are damaged. Using a suitable tool, carefully lift the black securing tab and disconnect the keyboard flexi 11 from the keyboard PCB See the diagram below: 6.

Disengage the 2 clips securing the keyboard PCB 12 and remove it. Holding the window 6 around the edges, carefully remove it from the unit. Care should be taken to protect both the window 6 and the exposed LCD 15 from accidental damage or dust contamination.

Undo the 4 screws 14 holding the light box assembly 18 in position and retain for later use. Remove the rear cover 39 and discard the connector panel seal Taking care to protect the LCD 15 , lay the unit face down. Unscrew and remove the high voltage shield Remove the HV cable assembly 19 and the fan connector Carefully unclip the chartreader flexi 28 from the chartreader Gently free the chartreader securing clip and remove the chartreader Using a suitable tool, carefully lift the black securing tab on the LCD to CPU flexi 16 and temperature sensor flexi