Mail will not be published required. This option is usually found under the boot sequence menu of the BIOS. Filed under: How To's Tags: boot from usb , flash drive , format windows xp from flash drive , install os , install xp , komku , make bootable flash drive , usb , windows xp on flash drive December 3, by: Prasanth Chandra.
Nellie says:. December 13, at am. Install os using pendrive or memory card says:. September 5, at pm. March 31, at am. Kirk PCgenius Campbell says:. October 24, at am. August 25, at pm. August 9, at pm. After you make a choice, click Next. Now, select USB drive for output device and select the correct drive from the list.
Then click Next to continue. The utility will now create USB rescue drive. It will check necessary components and download missing components from the server. Please notice that all existing data on the USB drive will be destroyed if you agree to this step.
The program will alert you before writing the USB drive. Ensure that there is i folder. You will need it. Reboot the system. When the system is being reboot, you need to enter BIOS configuration. In order to do that you can simply hit F1, F2, Delete or Escape. If you have doubts, the same key instructions will be there on the screen. Now, move to the section containing your boot devices. Provided that your USB device is added, it will be displayed on the screen. And if it is visible, you need to promote your USB device to the primary boot device.
Save all changes and exit the BIOS configuration. Is the USB device listed and does it have top priority? Have you correctly prepared the USB drive in step one? Restart the procedure. Does your USB drive properly support being booted from? Try another one! Don't worry though. Note: The above guide works with Windows XP only. Buy Now. Contact US. Insert the USB drive you intend to boot from. Instructions for doing so vary wildly from system to system, but generally entail the following: Reboot the system.
Go to the section that contains your boot devices. Exit from the BIOS configuration, saving all changes. Step 4: Prepping the Hard Disk You need to make sure that your hard drive is partitioned and formatted properly.
To repartition and format This procedure will destroy any data on the hard drive : Click the icon on task bar to launch a command line Window. Enter DiskPart to run the built-in disk management utility. For example, try the following: select disk 0 select the first disk. Unplug USB drive during post stage. Change your BIOS settings back to boot from hard disk again as needed.
Step After the successful completion of copying the files to your USB drive it will ask whether to unmount the Virtual temp drive or not. As you do not need it Select Yes. Step After the successful completion of the process close the cmd console. Now your pen drive is ready for the installation process.
While start up make sure that you set the first boot choice as your USB drive. To do this you have to enter to the bios and change the boot order to USB Disk as the first choice. This key is usually seen in the screen in the boot screen. For most of the systems it is DEL key. For HP and Compaq it is F10 etc. Go to the boot configuration tab and change the boot order. Select TXT mode for now. Step Follow the onscreen instructions. It is same as the usual setup process.
In the partition selection screen do not select you USB drive for install. Now first create a new partition and format your HDD using the setup. And again restart the process from step 15 by Quitting the current Install Press F3. Then you should get your HDD partition as C drive. Continue your installation. Step Now it will copy a set of files to the hard disk. After the process it will ask for reboot. Press Enter to reboot immediately.
Now you can continue your usual setup process. Follow the onscreen instructions carefully. After the setup process which usually takes 39 minutes, it will restart. Now boot from your Hard drive not the USB drive.
0コメント